-
Smart Car Robot Plastic Tire Wheel No load speed (6V): 100RPM No load current (6V): 60mA
-
The MCP4725 is an I2C controlled Digital-to-Analog converter (DAC). A DAC allows you to send analog signal, such as a sine wave, from a digital source, such as the I2C interface on the Arduino microcontroller. On board are SCL, SDA, VCC, and another GND for your basic I2C pinout.
-
-
This MEGA Sensor Shield V2.0 dedicated sensor expansion board assembly market a variety of advantages in one of the expansion board design, PCB Immersion Gold processing technology. Board not only all digital and analog interface to the steering gear line order form extended out, but also ad hoc Bluetooth module communication interface, SD card module communication interface, APC220 wireless RF module communication interface, and RB URF v1.1 ultrasonic sensor interface, independent expansion a more easy and convenient. For beginners, do not have to worry about cumbersome and complex circuit connection, will simplify this circuit sensor expansion board in the true sense, it can often be easily connected with the sensor.
-
The ADXL345 is a small, thin, ultra-low power 3-axis accelerometer with high resolution (13 bits) and measurement range of ± 16g. The digital output data is in 16-bit twos complement format and is accessible via SPI (3-wire or 4-wire) or I2C digital interface. Its high resolution (3.9 mg / LSB) enables measurement of tilt angle changes of less than 1.0 °
-
Main chip: Atmega16U2, 100% compatible to Arduino This Mega2560 is compatible with most shields designed for the Arduino Duemilanove or Diecimila. 54 digital input/output pins, including 16 analog inputs, 4 UARTs (hardware serial ports), Clock Speed: 16 MHz